High Strength Full 100% 3K Carbon Fiber Plain Weave Glossy Or Matte Sheet

Product Description

High Strength Full 100% 3K Carbon Fiber Plain Weave Glossy or Matte Carbon Sheet

Designed to meet the most exacting standards of any carbon fibre sheet, our Double A-Side High Strength smooth Carbon Fibre Sheet is manufactured from 100% carbon fibre reinforcement and pressed at high temperature and pressure to create a high performance double sided carbon fibre sheet with a smooth, high-gloss finish on both sides.

These high-quality carbon fiber sheets come in various sizes, made from 100%, 3K plain weave, carbon fiber and finished with a matt surface on both sides. Unlike many low-cost carbon sheets that are made by pressing two outer skins of carbon fiber over a carbon and resin core, these plates are made with layered sheets of carbon fibre and resin, making them the same strength all the way through.

Whether you’re making your own drone frames, car chassis, firewalls, bulkheads or any other custom designs that require high strength, lightweight material, these quality carbon fiber sheets are more than up to the task.

Typical Uses:

• General Engineering
• Robotics
• Aerospace
• Motorsport
• X-Ray/Metrology Equipment
• R/C Models

Advantages

• Good flatness (minimal taper or warp)
• High gloss finish on both sides
• Pin-hole free surface finish

Features:

1. Very light and very strong.
2. High strength and high modulus.
3. Excellent fatigue resistance.
4. Corrosion resistance.
5. Electrical conductivity.
6. Excellent Structural Properties.
7. UV Resistant Inhibited.
8. Non-Conductive Thermally.
9. Excellent planeness.
10. Very flexible.
11. Nice appearance.

Application:

1. UAV, RC Toy model, Aeromodelling, Helicopter Model.
2. Electrical products.
3. Shipbuilding.
4. Space aviation defense.
5. Sports equipment.
6. Automobile parts.
7. Wind power blades.
8. Spinning Reels Brake Rotor friction plate, Rocker.
9. Medical device(X-ray, DR).
10. Etc.

Single-Sided Carbon Fiber Plate Specification:

Could carbon fiber be a suitable material for a cutting board?

No. By its nature, the fibres would be exposed in use and so allow the ingress of moisture bacteria, etc., into the board’s structure. Unless the board was made using a high-pressure infusion system so that the bonding resin excused all air and filled all the minute cavities, it would not be suitable. This would be an expensive way to manufacture it and somewhat of an overkill on its design. It might have some possible uses, though.

FAQ:

1. Is carbon fibre cut resistant?

Yes, carbon fiber is cut-resistant.

Cutting carbon fibre with a knife is a bad idea; it can cause the blade to break, dull, or even get caught in the fibres, which results in the knife being difficult to remove.

2. Is cutting carbon fiber dangerous?

Carbon fibre cutting boards are known to be more dangerous than their counterparts because they have a higher probability of containing hazardous chemicals such as formaldehyde.